Forum

GMartin · Joined: Feb 5, 2010 Posts: 308

Jarek,

A long while ago I was able to create a ice topograph for a few designs. Now I find that the black background are is not fitting into the display. I have tried different ways of resizing to no avail.

When I create a new design with just the topograph in it with the default settings the black background extends to the edge of the borders in the element and has a piece on the side cutoff. If I double click on the topo element as if to change settings the image displays properly. I set up a routine so tht the topo hides when processing is starting and and shows 2 seconds later. That works fine but is a bit fussy.

If I use buttons and a value element to increase or decrease the amplitude range on the topo the the images is again disrupted. Using buttons to hide and show the chart resolves the issue Do you have some suggestions about use of the toptgraph that could help me out.

Thanks

George

The simplest way I could make this happen

GMartin · Joined: Feb 5, 2010 Posts: 308

I just found a very old version of the topograph that I created n 2015. I am not sure what version of BIoEra was current at that time. It works just fine. I chacked all settings and they are the same as on the new one thatdoes not work

jarek · Joined: Oct 22, 2007 Posts: 1073

I am not sure what happened for you.

I just added a new Topograph, connected it to SimulationSource and it seems to work fine.

There was no change in the Topograph code since the last time you used it.

GMartin · Joined: Feb 5, 2010 Posts: 308

Quick update on Topograph. Changing Left and right margins to 0 in chart properties allows the topograph to size peoperly