Forum

GMartin · Joined: Feb 5, 2010 Posts: 308

A couple questions.

when I do Synchrony training with 4 or 8 channels I would like to have only those sites show up on the topograph.
Currently it only works if all inputs are connected. I have set up an expression evaluator to send 0 to the unused inputs. This works OK but it is a bother to be connecting and reconnecting things when I change sites. Is there a possible way to get the topograph to work without all inputs connected.

Second question

It has taken me a long time to get the topograph set up and sized so that the active area is well centered. However, resizing even a small amount causes the image to size poorly and it then takes a long time to get it right again. I have made numerous changes in chart properties but can see no consistent results. Any hints/tips would be greatly appreciated.

George

jarek · Joined: Oct 22, 2007 Posts: 1073

In version 3.045 the Topograph element will not any more require all inputs connected.

Did you set \"Background image layout\" and \"Resize mode\" to FILL in chart properties?

GMartin · Joined: Feb 5, 2010 Posts: 308

Jarek,

Thanks. The topograph change will make a big difference.

I used a lot of different settings not sure which combination finally worked. I had a lot of trouble with one side or the other going out of the visible range

I will try it with your suggestions and let you know how it works.

George

jarek · Joined: Oct 22, 2007 Posts: 1073

When I resize my snippet with Topograph using those settings, all seem to be fine.

If it is not in your case, send me your snippet.