Forum

michael · Joined: Dec 29, 2011 Posts: 11

hello jarek,

i have a problem with disappearing 3d displays in a 4ch design. if i click to edit mode, i can see them and move them arround. when i click back to view mode, they disappear.

i had these problems before with a 2ch design, but the 3d displays, when they were not there after loading the design, reappeared after going to edit mode and then view mode again.

the 3d design consists of a bandpass filter(fullrange), fft transform, subvector and an 3d vector display. i copied this setup from one of your examples. i copied/pasted these 3d displays.

do you have an example design with a 2d display, just the bins, for seeing 50hz artefacts?

thanks for your help,
michael

jarek · Joined: Oct 22, 2007 Posts: 1075

Michael,

if a chart (any) is not showing properly after changing from edit mode to view mode, try to reload the design.

If the same happens after fresh start (or design reload) like in your case, send me the design, I will try to reproduce it here.

Jarek